Gliders > Slope Soaring
Quark 2M - Back to cutting innocent trees!
Fred:
:oops:
Wow, that good, really?
Ok, I must remove the fingers and finish to cover mine to give it a go! (So do you Mr B! :P )
Thanks again Mr Boyd for the comments, especially coming from a pilot of your class! :clap: :clap:
Was concerned a bit for the rudder, this is one of the hardest part to get right in size / effectiveness and must work without adding to much induced effects.
JohnPearson:
Fred just checked the CofG position:
75mm from the leading edge on the fuslage, or at the front edge of the front wing joiner hole pre drilled into the side of the fuselage.
Throws:
Elevator, as shown on the plan cut out (all flying tail) I used 60% expro rate on the elevator also.
Ailerons, 30mm again I used alot of expo 60%
Rudder as much as possible 40mm each way with 60% expro
Fred:
Thanks JP, I'll add your throws on the plan (I'm bad for that, I always put the maximum everywhere! :oops: )
JohnPearson:
Fred with those big ailerons you could use larger throws if you wanted to, a 30mm is a good starting point. however with the expro rates you can have the best of both worlds, a smooth flying fast glider one second, and a highly aerobatic plane the next, with full control throws used
Fred:
True!
And the ailerons are... well, big :mrgreen:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version