Gliders > Slope Soaring
Quark 2M - Back to cutting innocent trees!
Fred:
Hi Nico,
Welcome to the forum :D
To answer your question, yes, the wings are attached to the fuselage with the carbone rod (8mm), sliding in the carbone tubes (10mm).
The 8mm carbone rods are the wing joiners.
Then, as you can see on the plan, 2 hooks will held the wings to the fuselage (you can use rubberbands).
Hope this helps, but let me know if you need more details
Fred
Fred:
Oh, forgot, short kit not yet available, but should be soon! :D
venture:
--- Quote from: "Fred" ---
To answer your question, yes, the wings are attached to the fuselage with the carbone rod (8mm), sliding in the carbone tubes (10mm).
The 8mm carbone rods are the wing joiners.
--- End quote ---
thnx Fred, for the fast response.
The hooks, i had figured out.
Is the allevator held in place in the same manner , that is, with 2mm rods in the 4 mm tubes?
Please keep me informed in concern of the shortkit
thnx; Nico
Fred:
No problem at all,
Yep, same for the elevator :D
Fred:
Well, the Quark continue its travel around the World, this time in South America :D
Received this morning a mail from Brasil where the Quark will be flown during a aerobatic contest in the biggest slope event in Brasil :D
You can visit the website of this bunch of slopers from the other side of the Atlantic here : http://www.planabh.com.br/
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version