Gliders > Slope Soaring
Quark 2M - Back to cutting innocent trees!
Fred:
Hi George,
Very quickly (just heard that the plane with the Frenchies just landed!)
The gauge is to give the correct angle to the ribs and ailerons' ribs.
The Piece N1 on the plan, is put on a flat surface, then the ribs for the ailerons glued to it.
As you can see on the plan, the ribs are not at a 90 degrees angle at their leading edge!
So you use this template to have them glued correctly if you see what I mean :?:
Hard to explain, I try to find a photo later :D
GeorgeB:
--- Quote from: "Fred" ---Hi George,
Very quickly (just heard that the plane with the Frenchies just landed!)
The gauge is to give the correct angle to the ribs and ailerons' ribs.
The Piece N1 on the plan, is put on a flat surface, then the ribs for the ailerons glued to it.
As you can see on the plan, the ribs are not at a 90 degrees angle at their leading edge!
So you use this template to have them glued correctly if you see what I mean :?:
Hard to explain, I try to find a photo later :D
--- End quote ---
sorry Fred, I'm reading your words again and again, but still don't understand :oops: maybe photo helps :)
GeorgeB:
Can you specify anything else for me please :)
johnfireball:
Hi George,
I believe these are the angles Fred is referring to.
John.
GeorgeB:
--- Quote from: "johnfireball" ---
Hi George,
I believe these are the angles Fred is referring to.
John.
--- End quote ---
Thanks a lot John, for your explaining. :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version