Gliders > Slope Soaring

Quark 2M - Back to cutting innocent trees!

<< < (38/113) > >>

Richard Boyd:
Brilliant video Fred, bring your camera this weekend for the Quark is going to dance at the NI Slope Bash  :D
For anyone that missed the event post we are having our second Slope Fest on the slopes of the Sperrins (Slieve Gallion) this Saturday and Sunday, everyone is welcome and the winds look promising so it will be fun fun fun and a hotdog or 2 maybe eaten lol

GeorgeB:
Hallo from Prague,
small progress here :)


can somebody show me how rudder is connected with the servo?

and answer my questions on the picture below



thanks a lot
George

Fred:
Hi George,

This is some good progress!  :clap:

Ok, for the rudder, mine use closed loop cables, but you can use Robart snakes if you prefer, but I would personaly use cables. They exit by the holes at the end of the fuselage.

For your drawing, 90 degrees on the right : Yes
Don't mind the cuts (lines) that are on the 2 long pieces named N1. They are for the Laser Cut kit!

Now, talking about these 2 parts, I just realized that I did not name them right and placed on the plan!  :oops:

If you look carefuly at the plan and the pieces, this is easy to find which one goes where : the notches on the ribs will match the correct piece if you see what I mean.
Material is : top one on the plan : 2mm plywood (that's the piece that is the ailerons LE)
Bottom one : 3mm plywood (that's the piece that go at the end of the ribs of the wings)

This bad drawing should shed some lights  :D



Let me know if there are still parts that are unclear.

Fred

GeorgeB:
Thank you Fred, I understand,  but to be sure about the rudder,
can you make a detailed photo of your tail and servos please :wink:
George




--- Quote from: "Fred" ---Hi George,

This is some good progress!  :clap:

Ok, for the rudder, mine use closed loop cables, but you can use Robart snakes if you prefer, but I would personaly use cables. They exit by the holes at the end of the fuselage.

For your drawing, 90 degrees on the right : Yes
Don't mind the cuts (lines) that are on the 2 long pieces named N1. They are for the Laser Cut kit!

Now, talking about these 2 parts, I just realized that I did not name them right and placed on the plan!  :oops:

If you look carefuly at the plan and the pieces, this is easy to find which one goes where : the notches on the ribs will match the correct piece if you see what I mean.
Material is : top one on the plan : 2mm plywood (that's the piece that is the ailerons LE)
Bottom one : 3mm plywood (that's the piece that go at the end of the ribs of the wings)

This bad drawing should shed some lights  :D



Let me know if there are still parts that are unclear.

Fred
--- End quote ---

alibodin:
George,

You could to make things easier make the pieces A1 and A2 in one piece if you have long enough material. I think Fred has them in two parts so as to make the box of bits smaller.

AListair

ps Fred any news when the short kits will be available?

Navigation

[0] Message Index

[#] Next page

[*] Previous page