Gliders > Slope Soaring
Quark 2M - Back to cutting innocent trees!
GeorgeB:
--- Quote from: "Fred" ---Hi George,
Sorry, quick reply as it is a bit late, I'll take photos tomorrow to answer your questions.
Basically, don't worry about the holes in T1, this is only to pass your servo cables, that have no other functions.
In green, yes, don't glue! Use screws, as this will allow you to unscrew the servo tray if you need to do a bit of maintenance.
I feel your pain for the tubes / rod... My tube was 7mm inside, and had 8mm rods! :!: :!: Sanding, re-drilling of the tube etc etc :!: :!: :!:
--- End quote ---
I wanted to avoid sanding, but I see there is no other way :!:
Thank you Fred
GeorgeB:
--- Quote from: "Richard Boyd" ---Hi George, I have 10mm tube with 8mm I/D and alloy 8mm tube for the wing joiner.
I think there are 10 peices left in the workshop.
I am unsure of the exact price, but think the 10mm carbon tube cost me £8 per 1m lenght.
--- End quote ---
I appreciate your offer Richard, but I'll try to sand a little carbon rod like Fred said. Many thanks.
Richard Boyd:
Andrew and his mini Quark flying on the beach at Downhill, ground up slope soaring !!!!!!
[youtube]http://www.youtube.com/v/Pvm43zS27XA&feature=g-all-u[/youtube]
YOU CAN JOIN US AND FLY HERE AT OUR WEEKEND TRIP TO RATHLIN ISLAND !!!!!!!
Fred:
Thanks Richard for the video :clap:
Good to see the Micro Quark flying, looking good in that wind1 :D
I'll see anyway, I might consider producing that one too :D
Any words from Denis? Did he flew his model? :?:
Richard Boyd:
Hi Fred, Denis had to go into hospital and is now out and recovering, he intends to get the mini Quark in the air as soon as he is in better health and the temperature rises alittle on the mountain.
I hope to meet up with him this weekend at the Banbridge Model clubs glider tow fly-in on Saturday.
I will keep you posted.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version