Gliders > Slope Soaring

Quark 2M - Back to cutting innocent trees!

<< < (91/113) > >>

Nhalyn:
Hi guys !

Next step...

I've put 5x5mm balsa stick all around the canopy for stiffness purpose (as servo tray don't touch the sidewalls). This leads to modification of frame C3, but not on frame C2.
Also prepared the elevator rod (not finished servo side) : it will be carbon rod in this all wood glider...  ;D :o

Then, assembly on the fuse ! Nice curve !   :-[ :-X:-*

Fred:
 :-* :-* Nice build Jean Mi!
You have 2 months to finish it!  ::)

mario:
Good job
Depeche toi 8)

cicciopasticcio:
Hi all,

this is my first post here. I am also planning to build a quark. But I have one question... (I am not so an experienced builder..).
Which is the best method to glue the carbon tubes in the wing to the wing ribs? Cynao? Or 90 minutes epoxy?

Thanks!

Marco

alibodin:
I used cyno to secure them in place and then some epoxy to add some more strength.

Alistair

Navigation

[0] Message Index

[#] Next page

[*] Previous page