Gliders > Slope Soaring
Quark 2M - Back to cutting innocent trees!
Nhalyn:
Hello Marco ! Welcome...
For Carbon I use Cyano with great success. Just put a little grind with sand paper on the areas to be glued and it's strong.
Just put parts in the right place and use very fluid cyano to add glue.
Nhalyn:
Last news... Becoming better, fuse nearly complete. Color is comming ! 8)
Seems I need a pair of wing and a stabilizer... :o
cicciopasticcio:
--- Quote from: Nhalyn on February 13, 2017, 10:15:07 AM ---Hello Marco ! Welcome...
For Carbon I use Cyano with great success. Just put a little grind with sand paper on the areas to be glued and it's strong.
Just put parts in the right place and use very fluid cyano to add glue.
--- End quote ---
--- Quote from: alibodin on February 12, 2017, 18:12:22 PM ---I used cyno to secure them in place and then some epoxy to add some more strength.
Alistair
--- End quote ---
Hi, thanks to both of you! I look forward to complete the build in the next weekend, and the I will post pics!
Marco
Fred:
Hi Marco,
Welcome to the forum :)
Enjoy your Quak build, and do not hesitate to share photos or ask anything :)
Like the others, I used Cyano for my tubes. Then, a second pass, outside, with Cyano accelerator. The cyano becomes hard and really seal the tube to the ribs. Not sure if this is actually "working" but I felt better after I did it :) It's all in my head :)
@ Nhalyn: Looks very good!! :)
Keep up the great work! April is coming soon!
And finally, the Quark in the snow! Photos received from Sweden.. Or Norway, I can't remember! :-[ :-[
cicciopasticcio:
--- Quote from: Fred on February 14, 2017, 21:33:00 PM ---Hi Marco,
Welcome to the forum :)
Enjoy your Quak build, and do not hesitate to share photos or ask anything :)
Like the others, I used Cyano for my tubes. Then, a second pass, outside, with Cyano accelerator. The cyano becomes hard and really seal the tube to the ribs. Not sure if this is actually "working" but I felt better after I did it :) It's all in my head :)
--- End quote ---
Hi Fred, thanks! I will share pics for sure. Promise.
I am waiting for the balsa sheets to start the wing build. I think I will try Cyano+activator at first: however the fit between few ribs and the tube is slightly loose. so I may use epoxy as well where needed (I have a new UHU plus 90 minutes box). Or do you think Cyano+activator can be just fine also for loose fit? I never built a wing with a carbon tube spar so far..
Thanks and see you soon ,
Marco
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version