Gliders > Slope Soaring
Foam Quark
Happy Days:
Well done John, :clap: and it's nice to see a couple of young “pilots-to-be.” Did you make them out of foam & paper as well?
But I have a question John:
How are you going to stop the two wing halves from coming away from the fuse when in flight :?:
From your pictures I haven’t seen any method of holding the wings to the fuse.
Keith
johnfireball:
Hi Keith,
The wings are held by short pieces of silicon tube on a forward wing pin. It's a bit tricky to assemble but hopefully will do the job. On my plouf I put thin strips of masking tape on the wing joiner rod and these hold ok with friction and dont wreck the fuse on hard landing. I will only use the silicon tube if the wings loosen up as they are holding firmly at present with friction alone.
John.
Fred:
Hey John,
Your Quark is really looking good! :clap: :clap:
johnfireball:
Hi all,
There maybe a weather break tomorrow so might get first hopefully not last flight in before the new year, anyway batteries are being charged.
John.
Fred:
Hey John,
Do you know around what time you are going to fly?
Can come, but have to leave relatively early in the afternoon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version