Gliders > Slope Soaring

A big box...

<< < (12/15) > >>

Fred:
Ok, final setup of the machine done, and first cuts made!
All ready to go  :D

The mirror alignment was much easier than anticipated! You use scraps of paper and a "target" on the focus lens. Remove the machine safety to fire the laser in open air.
Quiet cool to burn those piece of paper to mark the target  :D

Anyway, after a few test in different materials, time to do the first cut and presto :

All the parts for my ASH25 wing joiner system / ribs (in 4mm plywood)



And the micro mini Quark  :P
In 3mm plywood, and in balsa





So that's it, the setup is done, and so far, I am very impressed withis piece of machinery. Lots of wood on order.
This close this chapter, time to open a new one!  :D

andrew wallace:
:clap:  :clap:  :clap:  :clap:  :clap:  :clap:  :clap:
good stuff Fred

orionis:
Yeah, nice job, Darth!  :D

Richard Boyd:
Lovely lovely work Fred !

mario:
au boulot :wink:

Navigation

[0] Message Index

[#] Next page

[*] Previous page