Gliders > Scale
33% Kaiser Ka-3
Fred:
Wait.. What are you doing here?!
BUILD!! :lol:
Not even time for beers!! :P
selleri:
Working... :wink:
Always time for a beer, not so sure if the build gains from it though! :lol:
selleri:
V-tail starting to come alive.
Few cuts with my little hacksaw, 8mm outer tube as I couldn't find a 7mm od. tube.
Tad of Hysol to keep it all together.
Squeesing the outer tube end together will keep the inner tube in place.
Sweeeet!
First change, v-tail servos in the tail. Hobbyking sells these re-badged MKS DS6125 servos, they shouldn't have any trouble moving their surfaces.
Not much left, just the bottom sheeting and access hatch for the servos. :)
erwan:
Hello
Very strong servo for V tail :D
nice work
Fred:
Very very nice! :clap: :clap:
Servos in the V-Tail is one of the mod on the new kit being produced :D
Also, on a side note, as your kit is from 2008, do you have diedhral on your wing? :?:
I have added a bit at some stage, I can post the templates if you want to modify the holes for the wing joiners in your wings :D
Purely cosmetic as mine does not have any, but it looks better on the ground :wink:
I'll post build photos of my new Ka3 this week end :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version