Gliders > Scale
1/3 scale Ka8b build
orionis:
Moi non, mais bravo quand même! :wink:
Fred:
Merki :lol: :D
Kits are coming, just have to wait for Ronan to build his prototype to confirm this is a go :D (je te contact a ce sujet Ronan plus tard :D )
Anyway, started to add a bit of "scale" details there and there, and the tube structure in the front, along the canopy frame etc.
Fuselage almost done :D
Left to do is the nose cone, and the sheeting at the front.
Mounting the rudder servo and push pull system.
Skid and wheel mounting (will work on that when I come back from the slope this afternoon :D )
Next week, I am away, so no work will be done :!: I was hoping to have the wings finished for the Glide in, but we'll see how it goes.
So far, build was like a walk in the park, only spending an hour or two each evening, took me a week to get to this stage :D
mario:
ok dis moi et je t appele :wink: :mrgreen:
Fred:
Ok, a bit more work done this afternoon :D
Removed the fuselage completely from the jig. Always a great moment for me :D
Time to glue the fuselage bottom, that will also be used to support the skid and the hook for the bungee.
This is made with one long piece of 3mm plywood, with the opening for the wheel (110mm diameter in my case). The wheel support is as per the full size.
The reference:
And out in the garden :D
The beauty and the beast... Will not tell you which one is which! :lol: :P :P
So, basically, fuselage is pretty much done.
I'm off South for work this week, so no more work will be done until next week end unfortunately :!: :!:
Also ordered the tube and rod for the wing (23mm tube, 20mm wing joiner).
Wings should be fairly easy to build, plan is printed, parts are waiting! :D
Fred:
Another on for the road :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version