Gliders > Slope Soaring
Anyone know of a plane I can actually buy?!
billscottni:
Blenderm tape (medical use) sticks to epp and is available on Ebay
angry_muppet:
It would be these little guys...
There are 4 per elevon, so I've spaced them approximately equal down the length. The Good Lady has donated a hair pin to the cause, so was able to poke glue into the slot I'd cut.
I think I'll give the glue a whirl. Worst that can happen is that I need to cut them off and tape them instead?
Happy Days:
Hmmm,….. can’t really make out what I’m looking at from that picture I’m afraid.
The easiest glue to use, if you are trying to get it into small gaps /crevices’ is thin ‘CA’ glue (superglue) It uses a capillary action to draw itself into the ‘hole’.
Wise move to involve the “Good Lady” :D . That way they tend to be a little less vitriolic when you come home with the inevitable Large Plastic Bag of Bits. :wink: (Ask me how I know. :roll: )
L. Keith
angry_muppet:
In this case, the Good Lady states "I'll be pi$$ed if you bring that home in bits after the time you've spent on it"!
Elevons seem to have glued ok... Only flight will tell.
As for flight... I don't know how the bits will fit!
The only thing below the battery is the receiver, and it's the only thing that can't be moved further than I have done already.
How good would a duck tape canopy be?
Happy Days:
No images being shown David! ;;;;;;;;;;probably because the pictures you are trying to upload are too big. Here’s a link to some free editing software. http://photofiltre.en.softonic.com/ (thank you Mr Fred) Max size for this form is 800,…….I think :?: .
( I like free software. Leaves more money for models :D :D )
As for the rx position, as long as the antenna isn’t ‘shielded’ by any electrically conductive material it should work fine.
I dare say a “Duck tape canopy” would work 8) . Only one way to find out! :lol:
Have you ‘Spun up the Prop’ yet?
L. Keith
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version