Gliders > Slope Soaring

The Micro Quark.. For when a Quark 2M is too big!

<< < (4/11) > >>

alibodin:
My Quark Mini Wings are looking good.

How does one cut the ailerons off from the wing. Carefully is my first thought :) Saw or knife or anything else?

Suggestions most welcome.

Thank you.

Alistair

johnfireball:
Hi Al,
      I put a few pieces of double sided tape on the spars, stuck a steel ruler on them and cut through the spars separately top and bottom with a knife. I then used a junior hacksaw blade to cut the ply ribs alligning the previous cuts and a knife for the balsa ones.
John.

alibodin:
John,

Thank for that makes sense, I knew it involved a long straight rule, the double side tape is what I was missing.

Managed to do it, took a while but slow and steady and it is done.

Now all ready for covering the model!

Ironing :)

Alistair

Fred:


It was raining yesterday  :mrgreen:

More at some stage, but very pleased with the result.
And only 3 hrs of work start to finish.

Today, the wings and servos... Hope it rains!  :P

Happy Days:
Fred, I’ve come to the conclusion that you are obsessed with time. :shock:  I imagine your house must be full of clocks. (In between the model gliders)

Whenever you post message about building something, you always mention how long it took you to do it. :P  

The new Micro is coming along nicely! :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page