Techniques > 3D printers and 3D printing
My first own 3D file and printing!
selleri:
--- Quote from: Fred on January 17, 2017, 22:10:50 PM ---Taddaaaaa! 8)
Ok, still learning this 3D file thing, I think I see what I did wrong, I try again tomorrow, but very happy with this failure :)
--- End quote ---
Wish my failures were that good! ;)
Fred:
Thanks Sverrir, you're very good :) but looks better in photo than in reality!
Anyway! Prigress, and relatively happy this time. I'm getting there :)
Printed in lower resolution as I think the grain will look nice once painted. I try to give it a go this weekend :)
Stay tuned!
Fred:
Feck it! Started the painting before I have to go back to work!
Hope that dry fast!
Humbroll Matt 78 here.
Fred:
And a bit more :)
Light wash with humbrol 11, bit of pale white, sky blue and gloss varnish where needed.
Looks the part already!
Just have to print the dials and make the glass, but that will be for another day :)
mario:
:-* j en veux un
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version