Gliders > Scale
Mini Pilatus B4 SilenceModel
mario:
Et hop....
Fred:
Joli!
Fred:
Thanks to our great weather, bit of work done on the Pilatus.
Everything is sanded before covering.
Servos are then installed using the very handy 3D printed servi frames by Jean-Louis Coussot! Handy and all fits perfectly. For once, I used what the wings were designed for, and the wing is equipped with 4 HS40, so full options wings.
Commands are basic Z bends, because slip free, nice and simple :)
Also prepared the elevator for tomorrow’s jobs with gluing the epoxy control horn.
Getting there!
Fred:
Bit more work over the last 2 days
Elevator is now moving, and so as the rudder, so that’s the electronic and moving thingy done!
On the photo of the servos, that extra black screw is a spare for the elevator, because we never know… and I have big fingers
Tonight’s work was to print the canopy frame and a pilot. Frame from Jean-Louis Coussot and pilot from me.
Bit of painting and cutting of the canopy and tomorrow, we should start to glue some stuff and work on the CG.
Getting there!
rogallo:
Looking good Fred, will we see it at the weekend?
R
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version