Planes > Indoor
Breeze Pro Arrived
DaveMc:
Brian,
I have a 2 cell 450mAh Lipo that I plan using aswell. I like high powered high rates flying outdoors. Hope I get on ok indoors too. :wink:
Baker
A Pain to build is right. I did not get it dead straight although it is pretty close. There is messy glue stains everywhere. It took me a while to get used to working with Depron and foam safe CA. I really need accelerator to do a half decend job.
Will do better the next time. This one will do for my first time out. If I smash it I wont be too upset.. :D
D
Aidan:
You really do need accelerator for using CA on depron. It's pretty quick and easy once you get the hang of it and have accelerator. I think you can use bread soda instead of commercial accelerator but never tried it. Not sure where I heard that either so try it on scrap first in case I've got it wrong!
You could also try UHU Por as an alternative to CA. If you're going to Cork on Saturday and you contact Richard Boyd (http://www.expressfly.org.uk) in advance I'm sure he can bring some accelerator, UHU Por or whatever you're after with him for you if you can't get it locally.
Aidan
Brian:
Hi,
The most safest foam kicker is water.
You can moisten one surface first and/or atomise some water on the area after assembly (this is best for alignment).
The reaction is a little slower than with normal kicker.
Brian
Navigation
[0] Message Index
[*] Previous page
Go to full version