Techniques > How to...

Fiberglass Repair

<< < (2/2)

rogallo:
Alan,
    carbon stitching is the answer here methinks. CA back all the cracks, get your dremel motor tool with glass reinforced cutting disk. Cut slots with the disk at right angle to the crack but not so deep that you cut through the fuse. Then get carbon tow and lay it in the well you have just created. then more CA. sand, prime and repaint.

If only it was that easy  

 :!:  :!:

Just a thought!

Ralph

Alan_Perse:
Thanks Ralph. I'll have a think about it. I'll defiantly CA the cracks though.

Navigation

[0] Message Index

[*] Previous page