Techniques > How to...

Brushless Motor / ESC... Help ...

(1/1)

skyhawk newbie:
At last my Brushless motor and ESC has arrived ( only waited 4 weeks )

Right I'm new to all this lark...so bear with me on this....

Brushless motor has 3 wires comeing out of it.... Red / Yellow / Blue....
The ESC has 3 black wires marked      A / B / C....

So what I wana know is what colour goes to what  mark   A / B / C  ????
Theres no manual with motor or ESC ..

Sean

billscottni:
Doesn't matter Skyhawk.

Use bullet connectors on each wire, then connect any wire on the esc to any wire on the motor.

Once all connected, run the motor. If it runs in reverse, swap over any two wires

skyhawk newbie:
Thanks Bill....   :clap:

Navigation

[0] Message Index

Go to full version