Planes > Indoor

Building and flying P-25 indoor (the elastic model airplane)

(1/4) > >>

alle:
Materials:

 several rods, taken from a plate 3 / 32, all measuring 25cm
 (being equal to 2 wings, 2 equal to the elevator and rudder, the preference of the elevator and rudder a little thinner and about 3 or 4 ribs for the wing, the elevator and rudder, like those)
 ca glue (use super bond)
 harmonic steel wire (one that is used to link aircraft)
 seam line (it's thinner)
 market sling (I use because it does not shrink in the heat of the trunk of the car)
 bead 1
 toothpick some
 a piece of balsa 3 / 32 and sanded to helice
 brass tube (at home fishing finds easy)




Tools


 steel blade or razor blade''''
 needle-nose pliers
 ruler


 Fuselage

part of the elastic traction is enhanced



[/URL][/img][/URL][/img][/URL][/img]

alle:
Making the propeller shaft bearings



 a piece of steel wire + - 3cm
 a brass tube
 Usually set with ca, then wrap the line tight and more ca


[/URL][/img][/URL][/img]

alle:
Fixing bearing and hook that holds the engine in the fuselage


[/URL][/img]


[/URL][/img]


[/URL][/img]

alle:
Making wings, elevator and rudders



 Wing 6-8 inches of rope and a wingspan of 25cm, using five straight grained.
 Elevator and rudder at least 2cm shorter the rope, the same scale, also use five straight grained.

 The division of the ribs on the wing, where the center in March 12.50 cm, the rest divided equally.
 The division of the elevator ribs are different because the rudders are together, the center in March, I leave 2 to 3 inches of rudder at each end of the elevator.


[/URL][/img]


[/URL][/img]


[/URL][/img

alle:
Screened wing, elevator and rudders.


 Open the bag
 Ca pass on the wing
 Cover the wing with plastic stretched over the finger and settle down to the plastic
 Do the same with the elevator and rudder

[/URL][/img]







[/URL][/img]

Navigation

[0] Message Index

[#] Next page