Gliders > Scale
ASK-13
andrew wallace:
as well as building the quark i'm still workin away at the wing
it's sheeted with 1/64 ply and this stuffs expensive it's nearly £18 for a 12" x 36" sheet so i made sure and measured it right :lol:
billscottni:
nice job Andrew. EVERYTHING is expensive theses days, not just ply! :cry:
andrew wallace:
i'm looking for the camera at the minute :!: so i hope to have some more photo's of the 1st wing section soon
i have all the capping strips all glued on and have the airbrake servo installed and working :clap:
i'm ready now to glue on the leading edge and the wing tip and that just leaves me to cut out the aileron and install aileron servo :clap:
i'm using futaba 3003 servo's for the airbrakes, elevator and rudder and hi-tec wing servo's for the ailerons (not the digital ones)
hoping now to get the second section started before christmas :D
andrew wallace:
i've had a bit of computer problems and thanks to my brother richard he has us up and running again :clap:
this is the second wing panel, it's amazing how easy the second wing is to build and i've noticed a few mistakes in the first wing :!: :!:
everything is set up dry no glue has been added yet :D
getting ready for a bit of christmas glueing :clap: :clap:
andrew wallace:
second wing almost finished, i'm ready to order another sheet of 1/64 plywood to sheet the top and bottom
airbrake installed
couldn't resist setting it all up :lol:
nearest wing proped up with a brush :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version