GliderIreland - Ireland RC Forum - Flying Model forum in Ireland
Techniques => How to... => Topic started by: stephen.shannon on June 25, 2014, 23:13:52 PM
-
I seem to be dominating this section of the forum .... :shock:
Anyway, in the past six months I've stripped the covering off two planes that were ARTF kits ie not built up and covered. I've noticed that the cover on these 'factory' made/built models appear much thinner than the solarfilm or oracover I've used to recover the models.....
Is there an explanation for this? Are the covering processes vastly different?
Thanks
Stephen
-
Simple explanation: cost!
Cheaper material, a fraction of the cost of Oracover.
-
I seem to be dominating this section of the forum ....
Stephen’s misses was telling me the other day that he enjoys a bit of
‘Domination’ :shock: (It’s all too kinky for me)
L. Keith