Well a nice day gone bad... :cry: :cry:
I went up to the hill today, weather was nice, a bit to windy, but nice.. Had my Cularis ready in no time. I was soooo looking forward to a few hours spent flying....
But as soon as the plane was in the air I´ve noticed way to much up trim..I was trying to correct this with the trimms on the Tx but even with max trim it was still going up...After 15 min I have landed no problemo...adjusted the elevator manualy and went fluing again...This time slightly nose heavy but way better than before...
After a 30 min A massive cloud just appeared from nowhere
I tryed landing before it starts raining...I was cca. 15m higt when srong wind pushed the nose straight down :cry: I was to low to do anything :cry:
The plane went down like a dart :cry: and thats the result :
What to do? :?: Just epoxy it together?will it be strong enough??the foam on the nose is a bit compressed... I have some glassfibre math left and epoxy resign..could I fibreglass the whole belly?...
Any advice welcome..
Peter