Author Topic: Parts for foam cutter  (Read 5316 times)

Happy Days

  • ISR Club Member
  • Newbie
  • *
  • Posts: 2184
    • View Profile
Parts for foam cutter
« on: September 24, 2015, 17:20:32 PM »
I've been asked by a friend of mine if anyone on the forum knows where to get the necessary parts to make a foam cutter.

When I say foam cutter I don't mean the type where a hot wire it tethered at one end. I'm talking about the type where the wire is attached to a pair of moving  vertical arms which are computer controlled in both the X and Y axis.

Little Keith
Try not to run out of airspeed, altitude and ideas....... all at the same time.


billscottni

  • ISR Club Member
  • Newbie
  • *
  • Posts: 1456
    • View Profile
    • http://www.nimsa.co.uk ; www.billscott.org.uk
Parts for foam cutter
« Reply #2 on: September 24, 2015, 21:48:14 PM »

Happy Days

  • ISR Club Member
  • Newbie
  • *
  • Posts: 2184
    • View Profile
Parts for foam cutter
« Reply #3 on: September 25, 2015, 08:08:44 AM »
Phew, thanks Bill :clap:

It'll take me a while to sift through that lot :D

L. Keith
Try not to run out of airspeed, altitude and ideas....... all at the same time.