1
Scale / Re: Seagull Ka8b - Engine install and mods
« on: December 30, 2021, 16:34:41 PM »
I'm afraid I don't remember but if you look for the motor you should be able to find the specs.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
3
Misceleanous / Re: Goodbye old friend :( Titine is dead!
« on: June 14, 2018, 23:52:09 PM »
Good times were had with the help of that car! 
6
Club Talk / Re: Find out what our Icelandic friends were up to this year!
« on: January 23, 2017, 23:35:23 PM »
Then the local viewers complain about the lack of engine sounds... hard lot to keep happy! 
Must be that inbuilt wind filter!
Must be that inbuilt wind filter!
7
Scale / Re: Annother Islandmodels 1/3 Scale Ka8b build log
« on: January 23, 2017, 21:07:20 PM »
Looking good! I'll keep Kate warm if you need to send her away...
I use a HVLP touch-up gun with a 1.0mm nozzle for among others my Ka3.
I use a HVLP touch-up gun with a 1.0mm nozzle for among others my Ka3.
8
Club Talk / Re: Find out what our Icelandic friends were up to this year!
« on: January 23, 2017, 20:59:03 PM »
Cheers, I'll be hosting a seminar at Cork Uni. during my next visit, "RC Model Icelandic and how to tell it apart from made up words!".
Nahhh, I had to give upp dinner too! B rolls aren't just good during lunch!
The wind is a constant blow, no pun intended, but hopefully it'll be a much less problem for this year as I believe a suitable mic with a wind cover will be used with the videocamera, or so I'm told.
Nahhh, I had to give upp dinner too! B rolls aren't just good during lunch!
The wind is a constant blow, no pun intended, but hopefully it'll be a much less problem for this year as I believe a suitable mic with a wind cover will be used with the videocamera, or so I'm told.
9
Club Talk / Re: Find out what our Icelandic friends were up to this year!
« on: January 18, 2017, 22:57:27 PM »
10
3D printers and 3D printing / Re: My first own 3D file and printing!
« on: January 18, 2017, 01:17:11 AM »Taddaaaaa!
Ok, still learning this 3D file thing, I think I see what I did wrong, I try again tomorrow, but very happy with this failure
Wish my failures were that good!
11
Club Talk / Re: Find out what our Icelandic friends were up to this year!
« on: January 11, 2017, 22:30:07 PM »
What! You didn't like 2 hours playtime compressed down to 10 seconds!!!
Began as a joke few years back but now I always do one, great for a quick reminder after you've seen the whole thing, if you can stand it that is.
Began as a joke few years back but now I always do one, great for a quick reminder after you've seen the whole thing, if you can stand it that is.
13
Club Talk / Re: Find out what our Icelandic friends were up to this year!
« on: January 11, 2017, 00:38:39 AM »
My pleasure... the video will be published in a week. 
https://www.youtube.com/watch?v=xTfsDxkQFZU
No Irish pictures in the 2016 edition, couple in the 2015 issue.
Now I think I'll need some Irish scenery in the 2017 edition, we better start checking the calendar!
https://www.youtube.com/watch?v=xTfsDxkQFZU
No Irish pictures in the 2016 edition, couple in the 2015 issue.
Now I think I'll need some Irish scenery in the 2017 edition, we better start checking the calendar!
14
Slope Soaring / Re: Sloping Denmark F3F Eurotour and World Cup 2016
« on: September 10, 2016, 20:18:42 PM »
Cheers Keith!
Maybe they like jets.... or glider pilots are mostly single.
Only just come accross this Sverric. That's one very comprehensive report, thank you.
Just one observation, there was a decided lack of females at the meeting. What does that say about our hobby I wonder?
Maybe they like jets.... or glider pilots are mostly single.
15
Slope Soaring / Re: Sloping Denmark F3F Eurotour and World Cup 2016
« on: September 09, 2016, 20:10:00 PM »
The F3F World Championship is only a few week away. Here's is a video from the Sloping Denmark Eurotour & World Cup meeting this spring.
https://www.youtube.com/watch?v=iXs-R9usTXs
https://www.youtube.com/watch?v=iXs-R9usTXs