Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - AndyB

Pages: [1]
1
Misceleanous / Mt Leinster
« on: January 23, 2022, 09:11:13 AM »
Hope everyone is having a better weekend than this guy. (Found on Reddit)

2
Slope Soaring / Build attempt / learning process
« on: November 20, 2020, 17:09:20 PM »
Is this a good place for a build log, or should it be in a different section?

I've started to build a monster, and have had some good results, well good enough to share.

3
Misc / Ply or Hard balsa
« on: October 10, 2020, 17:27:37 PM »
Hi All,

Short stort long; Im testing out some build techniques and am sheeting some foam core wings. Im looking for some guidance as to what materials to use and where to source. Some of the build blogs Ive seen people are using 1/32 or 1/64 ply, but from my searching, this is very expensive (defo the 1/64) and prob overkill too. Is there an equivalent in hard balsa or something else, what do you guys think?

Each wing sections is about 750mm.

4
Slope Soaring / PSS porn
« on: September 09, 2020, 19:56:23 PM »

5
Thermal / Flat field / How / where to start?
« on: January 17, 2020, 14:31:52 PM »
Hi all,

I have just finished a build of a 2m RES glider and need some guidance. I haven't flow a glider in over 20 year and even then it was not RC.

I'm assuming the best place to start is a wide open field with little to no wind and do some hand throws and see that it's all flying straight and that I have my CG setup all right.

Then I would love to move to slope soaring.

Do I need insurance?

Any advice / guidance would be very helpful

Pages: [1]