Author Topic: Wing Setup (Read 7173 times)

error404 · « **on:** October 16, 2009, 15:13:25 PM »

Hi all,

I am putting together a flying wing and just got stuck at this (simple) problem.

When i push the stick up, the right aileron moves up and left aileron down and opposite when stick is pushed left!
When i push the stick left, both ailerons go up and opposite when pushed right!
I do not plan on flying with my optic 6 sideways

What is the best solution i could try for this? I did not have time to try anything yet but will do over the weekend, read the manual again.

Using Channel 1 for right servo and Channel 2 for left servo as suggested in manual, also not using v tail mixer but have one if i need it.
Ta

Anthony

Alan_Perse · « **Reply #1 on:** October 16, 2009, 15:26:44 PM »

You will need to use a delta mixer. Thats a mixer specially made for flying wings. The mixer is probably programed into your transmitter already, you just need to turn it on. I assume the Optic 6 transmitter has a delta mixer.

error404 · « **Reply #2 on:** October 16, 2009, 15:32:27 PM »

Alan,

It mentioned to switch on Elevon Mixing which i did.

I will check tonight for the delta mixer, i'm sure the function is on it.

Thanks

Alan_Perse · « **Reply #3 on:** October 16, 2009, 15:36:22 PM »

I think the Elevon mixer is the same as a delta mixer. If thats the case may be the servos are connected to the wrong channels.

error404 · « **Reply #4 on:** October 16, 2009, 15:38:09 PM »

I will try that. :oops:

Alan_Perse · « **Reply #5 on:** October 16, 2009, 15:42:57 PM »

Don't worry. I have made the same mistake as well. Had quite a number of head scratching moments

. Trial and error.

Fred · « **Reply #6 on:** October 16, 2009, 16:48:28 PM »

Hi Anthony,

Or swap channel 1 and 2 on the receiver...
I had a few MC18 nonsense moments too...

error404 · « **Reply #7 on:** October 19, 2009, 09:27:16 AM »

Problem fixed, just had to swap the channels.

News:

Author Topic: Wing Setup (Read 7173 times)