« previous next »
Pages: [1]   Go Down

Author Topic: Brushless Motor / ESC... Help ...  (Read 4681 times)

skyhawk newbie

  • Newbie
  • *
  • Posts: 142
    • View Profile
Brushless Motor / ESC... Help ...
« on: November 30, 2010, 15:26:46 PM »
At last my Brushless motor and ESC has arrived ( only waited 4 weeks )

Right I'm new to all this lark...so bear with me on this....

Brushless motor has 3 wires comeing out of it.... Red / Yellow / Blue....
The ESC has 3 black wires marked      A / B / C....

So what I wana know is what colour goes to what  mark   A / B / C  ????
Theres no manual with motor or ESC ..

Sean
Logged
Too many to name
Gliders/Planes/EDF Jets.16 total...
cars.
hpi Baja

billscottni

  • ISR Club Member
  • Newbie
  • *
  • Posts: 1459
    • View Profile
    • http://www.nimsa.co.uk ; www.billscott.org.uk
Brushless Motor / ESC... Help ...
« Reply #1 on: November 30, 2010, 15:52:10 PM »
Doesn't matter Skyhawk.

Use bullet connectors on each wire, then connect any wire on the esc to any wire on the motor.

Once all connected, run the motor. If it runs in reverse, swap over any two wires
Logged

skyhawk newbie

  • Newbie
  • *
  • Posts: 142
    • View Profile
Brushless Motor / ESC... Help ...
« Reply #2 on: November 30, 2010, 19:10:34 PM »
Thanks Bill....   :clap:
Logged
Too many to name
Gliders/Planes/EDF Jets.16 total...
cars.
hpi Baja
Pages: [1]   Go Up
« previous next »