1
Slope Soaring / Quark 2M - Back to cutting innocent trees!
« on: December 06, 2012, 20:30:05 PM »
Looks good!
Is there any news about a (short) kit?
greets, Nico
Is there any news about a (short) kit?
greets, Nico
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Slope Soaring / Quark 2M - Back to cutting innocent trees!
« on: February 03, 2012, 12:48:24 PM »Quote from: "Fred"
To answer your question, yes, the wings are attached to the fuselage with the carbone rod (8mm), sliding in the carbone tubes (10mm).
The 8mm carbone rods are the wing joiners.
thnx Fred, for the fast response.
The hooks, i had figured out.
Is the allevator held in place in the same manner , that is, with 2mm rods in the 4 mm tubes?
Please keep me informed in concern of the shortkit
thnx; Nico
3
Slope Soaring / plans
« on: February 03, 2012, 11:12:37 AM »
Hello;
I have downloaded the plans and taped them together, but one thing i don't understand;
how are the wings attached?
By means of an 8 mm carbontube sliding in the 10 mm main spars?
Same with the alevators.
Is there a shortkit availeble?
thnx; Nico
I have downloaded the plans and taped them together, but one thing i don't understand;
how are the wings attached?
By means of an 8 mm carbontube sliding in the 10 mm main spars?
Same with the alevators.
Is there a shortkit availeble?
thnx; Nico
Pages: [1]