Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Fun Flyer

Pages: [1]
Wanted / Re: Very Thin Ply
« on: April 02, 2018, 14:01:00 PM »
Hi Jonzjob and welcome. I got the ply from Lindinger and although it was packed quite well it did suffer some crush damage in the post. However, there was lots left for what I needed, sheeting the rear fuz on a small electric DH Dragon. Another long term project I'm afraid.

Wanted / Re: Very Thin Ply
« on: November 17, 2016, 22:27:34 PM »
Thanks Fred, but its on the way thanks to Manolo.  I've never used 0.4 ply before.  It must be almost transparent.

Wanted / Re: Very Thin Ply
« on: November 16, 2016, 10:32:54 AM »
Thanks Manolo.  That looks like a good option so I've placed an order.  Lots of other interesting bits and pieces on their site too.

Wanted / Very Thin Ply
« on: November 14, 2016, 17:17:09 PM »
Hi can anyone suggest a source of 0.4mm (1/64) ply, or an alternative.  I need it to sheet the forward fuz of a small model so it needs to be a little bigger than 450 x130.

Slope Soaring / Re: new kid on the block
« on: April 14, 2016, 09:51:30 AM »
Hi Karel, I hope the weather here is not too much of a shock for you!  Do you fly only gliders?

Slope Soaring / Who is building what for 2015?
« on: November 12, 2014, 17:26:35 PM »
Hi John, what covering did you use for the Auster and where did you get it?
I need some for a little rubber FF job.
Thanks in advance.

Misceleanous / Green Models
« on: October 01, 2014, 12:33:37 PM »
Thanks, I hadn't thought of that but it worked.  It seems that the Model Shop is only staffed on Saturday mornings.

Misceleanous / Green Models
« on: October 01, 2014, 11:55:58 AM »
Hi, can anyone tell me if Green Models are still trading?  There's no answer to the phone number on the website.

Pages: [1]